? ? ? ?

1. Hit the cable stripper switch and the power indicator light starts to use it.

2, pay attention to the internal and external machine no obvious abnormal sound, if there is a suspension operation must stop, please maintenance personnel to determine whether it needs repair.

3, carefully selected knife: operated by the designated personnel, must be better than the support tool of the blade, the comparison of the knife is correct, after the knife is completed, you must use the manual test, first turn off the power terminal machine, press the button, use the special wrench Shake the driven pulley terminal machine, the stroke is the largest, if the hand does not move, then consider whether excessive pressure or other problems, check and debug. In the lock screw, check accordingly and confirm that there is no need for looseness.

4, pay attention to charging: need to hit the terminal equipment, the hex wrench adjusts the use of the feeding plate, so that the terminal can easily pass, whether to send the appropriate visual material position, if not, adjust, use the hexagonal wrench to release the lock Tight screw feeder, dynamically adjust the rod diameter of the rod to adjust until the best, then lock the machine to tighten the screw and start the action.

5, tensile testing machine: Well, when the waste line is tested, the tensile test, see the specific operation method of the "pull test bench" as follows: the main reference value, the tension test zero key is zero, the terminal line test clamp, Test, if the measured tensile force is not within the standard range, please adjust the maintenance personnel until the standard value is reached.

6, the production of 10 pieces of IPQC first piece confirmed, can be inspected, can be mass-produced, in the terminal operator in the production process must check whether there are plastic bags, hanging and other bad, one end pull test every hour.